5 Operation
5.5 Sensor coupling process
The fifth wheel coupling is open and ready to cou-
ple.
Drive the tractor unit under the semi-trailer.
Raise the fifth wheel using the air suspension
until the fifth wheel coupling plate contacts the
skid plate.
For a sensor coupling with skid plate detection
(3 sensors), the display now switches on
automatically.
ADVICE!
For a sensor coupling with skid plate detec-
tion (3 sensors), the “Open (red)” display
starts flashing and a signal tone sounds
if the fifth wheel plate loses contact with
the skid plate during the coupling process.
Restore contact to the skid plate within 10
seconds, otherwise the system will switch
off and you should restart the coupling
process.
EN
Sensor JSK MUB 007 001 M01 (REV-C) 07/2020 13
To Next Page
Loading...
Need help?
General
