Jøtul F 602 CB - Default Chapter; Table of Contents

2
F 602 CB 139677_R04 April 2017
NOTE: It is normal for a new, painted stove
to emit odor and smoke during initial fires,
depending on temperatures over time. This is
caused by the curing of the high temperature
paint and manufacturing materials. This
condition can be alleviated by opening
a window or door to provide additional
ventilation.
Table of Contents
Combustion Specifications,
Building Codes, .................................................................3
1.0 Safety Notices ................................................................3
2.0 Initial Assembly
2.1 Inspect Contents ................................................................... 4
2.2 Flue Collar Reversal .............................................................. 4
3.0 Installation
3.1 Chimney Connection .......................................................... 4
3.2 Wall Pass-throughs .............................................................. 4
3.3 Chimney Requirements ...................................................... 5
3,4 Hearthmount to a Fireplace .............................................. 5
3,5 Factory-built Prefabricated Chimney .............................. 5
4.0 Clearances Requirements
4.1 Floor Protection ..................................................................... 6
4.2 Alternate Floor Protection .................................................. 6
4.3 Clearances to Combustible Materials ............................. 6
4.4 Rear Heat Shield .................................................................... 6
4.5 Wall Protection ..................................................................... 6
4.6 Alcove Clearances ................................................................. 6
4.7 Fireplace Mantel and Trim Clearances ............................ 6
5.0 Operation
5.1 Combustion Efficiency......................................................... 7
5.2 CO Emissions ......................................................................... 7
5.3 Wood Fuel and Performance ............................................. 7
5.4 Air Flow and Control ............................................................ 7
5.5 Break-in Procedure ............................................................... 8
5.6 Top-down Fire Starting ....................................................... 8
5.7 Adding Fuel ........................................................................... 9
5.8 Open Door Fire-viewing ...................................................... 9
5.9 Ash Removal........................................................................... 9
6.0 Maintenance
6.1 Glass Care ............................................................................... 10
6.2 Glass Removal ....................................................................... 10
6.3 Gaskets .................................................................................... 10
6.4 General Inspection ............................................................... 10
6.5 Chimney System ................................................................... 10
7.0 Illustrations
7.1 Clearance Chart ..................................................................... 11
7.2 Figures ..................................................................................... 12
8.0 Part List ......................................................................... 17
9.0 Appendix A - Alternate Floor Protection ........................ 17
10.0 Warranty ............................................................................. 18
Standards
The Jøtul F 602 CB solid fuel heater has been tested and
listed to :
U.S. Standards: ANSI/UL 737 and ANSI/UL 1482.
Canadian Standards:
CAN/ULC-S627-M00 and CAN/ULC-S628-M93
Certified Safety Tests performed by:
Intertek Testing Services, Middleton,
Wisconsin U.S.A.
Manufactured by:
Jøtul North America, Inc.
55 Hutcherson Drive
Gorham, Maine 04038, USA
and
Jøtul AS, P.O. Box 1411, Fredrikstad, Norway
This heater meets the 2015 U.S. Environmental
Protection Agency’s emission limits for wood
heaters manufactured after May 15, 2015.
This heater may not to be sold after May 15, 2020.
WARNING !
THIS WOOD HEATER HAS A MANUFACTURER-SET
MINIMUM LOW BURN RATE THAT MUST NOT BE
ALTERED. IT IS AGAINST FEDERAL REGULATIONS TO
ALTER THIS SETTING OR OTHERWISE OPERATE THIS
WOOD HEATER IN A MANNER INCONSISTENT WITH
OPERATING INSTRUCTIONS IN THIS MANUAL.
THE JØTUL F 602 CB IS NOT APPROVED FOR USE IN
MOBILE HOMES.