Joy MagConnect User Manual

Seat Bolt | Bolt Mount
There are four different mounting options that can be
utilized for securing the mount to a vehicle bolt. There
are a few things to consider when choosing the best
location for the bolt mount. When possible the arm at the
base of the mount should run perpendicular to the
vehicle floor. This provides ultimate support of the
mount. Included are three bolt brackets along with a
base that should be utilized to accomplish this.
Choose the best option based on the hardware in the
vehicle while ensuring configuration provides optimal
mount stability.
Flat Horizontal Surface: Follow
Mounting Option 1 on page 2.
Flat Vertical Surface: Follow Mount-
ing Option 3 on page 3.
Flat Horizontal Surface Obstructed
Bolt: Follow Mounting Option 2 on
page 2.
Choose a location
(a) 90º raiser bracket x1
(b) 90º bracket x1
(c) 180º bracket x1
(d) support bracket x1
(e) washer x1
(f) screw x1
(a)
(e)
(i) (j)
(f)
(g)
(h)
(b) (c)
(d)
Package Contents:
(g) screw nuts x2
(h) support foot x1
(i) support foot cap x1
(j) base x1
Angeled Surface: Follow Mounting
Option 4 on page 3.
1
INSTALLATION GUIDE MagConnect HD Seat Bolt | Bolt Mount
™
Support
For questions or concerns please contact us at:
Customer Service Support
Toll Free: +1.877.JOY.FACT (877.569.3228)
support@thejoyfactory.com

Joy MagConnect Specifications

General

Rotation	360 degrees
Adjustable Height	Yes
Mounting Options	Wall
Material	Aluminum
Tilt	Adjustable
Color	Black
Compatibility	Tablets and other devices with MagConnect compatibility

Summary

MagConnect HD Seat Bolt | Bolt Mount Installation

Mounting Option 1: Flat Horizontal Surface

Install the mount on a flat horizontal surface by removing the vehicle bolt, securing the base with the bolt, and attaching the mount to the base.

Mounting Option 2: Obstructed Bolt

Install the mount on an obstructed bolt surface using the 180° bracket, securing it tightly for additional support.

Mounting Option 3: Flat Vertical Surface

Install the mount on a flat vertical surface using the 90° bracket and support bracket, ensuring a tight connection.

Mounting Option 4: Angled Surface

Install the mount on an angled surface using the 45° bracket and support bracket, ensuring a tight connection for stability.

Adjustable Tray Installation and Use

Attach Brackets to Tray

Attach rubber pads to bracket tips, then attach the brackets to the tray.

Use Tray with Device

Extend tray brackets, place device, and secure tightly to the device's edge.

Use Tray for Keyboard Case

Place tray flat, expand brackets, position keyboard, and secure brackets tightly to its edge.

Extending & Rotating the Mount Arms

Release latch, pull arm upward, secure by turning latch, and adjust/tighten knobs for desired position.