JOYEE ZJ9610 - Preliminary Adjustment of the Needle Height

9.03.02 9620
Neelde position in sewing direction on the 9620
 

，。
Requirement
The needle should be positioned in the centre of the needle hole as seen
in the direction of sewing.
● （  ）。
●
1 2
1 2 RequirementAdjust needle bar (screws and ) according to the .
9-3
 Adjustment
1-7
1.03 
Arm Parts
9.03.03
Prelininary adjustment of the needle height

9.03.03
Prelininary adjustment of the needle height


，21 mm。

，21 mm。
Requirement
When the needle bar is at top dead centre, there must be a clearance
of approx. 21mm between the needle point and the needle plate.
Requirement
When the needle bar is at top dead centre, there must be a clearance
of approx. 21mm between the needle point and the needle plate.
●  （ ），。
●
12
12
Requirement
Adjust needle bar (screw ). Without turning it, according to the
.
●  （ ），。
●
1 2
1 2
Requirement
Adjust needle bar (screw ). Without turning it, according to the
.
9-4
 Adjustment
 Adjustment
1-6
1.02 
Needle head Parts（9620）

 19 0* 260 6  10
Zj 96 10、9620、9625、9630
08 .0 4.2