JOYEE ZJ9610 - Needle Rise, Hook Clearance, Needle Height and Needle Guard on the 9625

9.03
Adjusting the basic machine

9.03.01 9625 9630 9610 、  
Needle position in sewing direction on the 9625 9630 and 9610、

，，
。
Requirement
With the stitch length set at its minimum, the needle should be positioned
in the centre of the needle hole, as seen in the direction of sewing.
● 。
● （1）。
●
●
Set the minimum stitch length.
Adjust needle bar (screw ) according to the .1 Requirement
9-2
 Adjustment
1-8
1.03 
Arm Parts
9.03.04 9625 ，，
9.03.04 9625 ，，
Needle rise, hook clearance, needle height and needle guard
on the 9625
Needle rise, hook clearance, needle height and needle guard
on the 9625

“ ”， 
，  。
  。
 。
0.8 :
1.
2.
3.
2.0 mm
0.05 0.1 mm
0.8 1.0 mm
6

“ ”， 
，  。
  。
 。
0.8 :
1.
2.
3.
2.0 mm
0.05 0.1 mm
0.8 1.0 mm
6
Requirement
2.0 mm
0.05 0.1 mm
0.8 1.0 mm
6
With the needle bar positioned after bottom dead centre and the
stitch length set at 0.8 :
1. the hook point must be at needle centre with a hook-to-needle
clearance of to ..
2. the top of the needle eye must be to below the hook point.
3. The needle guard must touch the needle lightly.
“”
Requirement
2.0 mm
0.05 0.1 mm
0.8 1.0 mm
6
With the needle bar positioned after bottom dead centre and the
stitch length set at 0.8 :
1. the hook point must be at needle centre with a hook-to-needle
clearance of to ..
2. the top of the needle eye must be to below the hook point.
3. The needle guard must touch the needle lightly.
“ ”
9-5
 Adjustment
 Adjustment
1-5
1.02 
Needle head Parts

 19 0* 260
6  10
Zj 96 10、9620、9625、9630
08 .0 4.2