D2 Load defaults:
Choosing this menu and confirming with yes (YS), set the control unit at factory defaults.
RC release torque at work end:
Enabling this function, the motors reverse direction for a while to release the torque at end of
work .Use up/down to choose yes(YS),not (NT) or exit(EX). Push enter to confirm.
EO Enable opening analogue edge:
Enabling this function it’s enabled the edge active in opening period. Choose yes(YS) is enables the
edge.
EC Enable closing analogue edge:
Enabling this function it’s enabled the edge active in closing period. Choose yes(YS) is enables the
edge.
Ar Enable automatic transmitters learning:
Enabling this function it’s possible to insert new transmitters without accessing base menu. Refer to
“Automatic transmitters learning”.
C5 Enable kickback stroke:
In this menu you can enabled the stroke at start to unlock electric lock and the final stroke to lock it.
rM Radio mode:
In this menu it’s possible to modify how transmitters work with the control unit.
5T- Step by step mode: Each button (code) of the transmitter is entered separated by the others,
Codes learned on C1 work as “Start command”. Transmitters learned on C2 word as “Pedestrian
command”.
r1- Learning a code from a transmitter, it enables all the four buttons of transmitter wording with the
control unit. Sequence is: Button1=open command, Button2=close commend, Button3=Pedestrian
commend, Button 4=stop commend.
r2- Learning a code from a transmitter, it enables all the four buttons of transmitter wording with the
control unit. The sequence is as above, except buttons3 and 4 inverted.
To Next Page
Loading...
