Need help?Do you have a question about the JOYTECH PK300DC and is the answer not in the manual?
Diagram illustrating the overall setup and components of the gate opener.
Detailed dimensions for the PK300DC and PK350DC main gate opener units.
Steps for preparing the gate and ensuring correct initial conditions before mounting.
Dimensions and physical specifications of the gate opener control box.
Critical safety warnings and precautions during installation and operation.
Diagrams and descriptions for connecting the control board and its components.
Adjustments for slowdown speed and obstacle detection sensitivity.
Procedure for setting opening and closing limit stops for the gate travel.
Configuration options for gate operating logic (step-by-step, auto-closing).
Learning, deleting, and managing remote control transmitters.
Procedures for learning automatic or manual gate working times.
Setting the pause duration between gate cycles (0-99 seconds).
Controlling motors individually in dead man mode for safety.
Modifying working times, slowdown, delay, and lock activation for motors.
Setting or verifying if the gate operates in single wing mode.
Resetting the control unit to factory default settings.
Configuring torque release and analog edge behavior for gate operation.
Enabling direct transmitter learning without the base menu.
Enabling kickback stroke and configuring radio modes for transmitters.
Guidelines for regular checks and safety considerations for the gate opener.
General| Power | 300W |
|---|---|
| Operating Temperature | -20°C~+55°C |
| Protection Level | IP44 |
| Power Supply | 220V/50Hz |
| Voltage | 220V |
To Next Page
