JPRiDE JPT2 - RX transmitter usage; 4.1 In RX status bluetooth pair and connect




4.RXtransmitterusage
4.1InRXstatusbluetoothpairandconnect
A．
In power off status pull TX/RX button to RX side，then long press MFB 2 seconds,
after blue LED flashes twice,
JPT2 power on, when paring list is clear (JPT2 didn’t
connect any devices before), power on and automatically enter into pairing mode
B．Power on the unit in standby status, short press“Paring button”（last for 0.2 second）
enter pairing mode, Blue and Red LED flashes alternately; in connected standby status,
long press“paring button” 3 seconds can force out connected status, enter into new
paring mode
C．Put JPT2 with your smart phone (laptop , tablet) together, open the smart phone’s
bluetooth function, and click search, click connect when
JPT2 appeared
D．After connect successfully, blue indicator LED long lit, connect headset or speaker
with
JPT2 by audio cable or optical fiber, and play music in your smart phone (after
playing music the blue indicator LED disappeared) then can listen to music came from
smart phone
E．When you want to use in AUX mode, just insert the Φ3.5mm audio cable then SPDIF
mode automatically switch to AUX mode; when you want to use in SPDIF mode，pull the
Φ3.5mm audio cable out then automatic switch to SPDIF mode








