Chapter8 Copying Recorded Data in PC Card
Playback Software / Instruction Manual
89
(5) Eject a PC card from VDR/S-VDR, and insert it into PC card slot on your PC.
Click [Import] button and select the following file in the PC card in order to import VDR
configuration information (SysInfo.dat). PC card drive differs depending on your PC.
＊:
\Init\SysInfo.dat
(6) Check quantity of engine, rudder, thruster and propeller and others which were imported by
VDR/S-VDR configuration data, which were registered when VDR/S-VDR was installed.
Quantity selection
If the [Import] button is clicked and a SysInfo.dat file is not imported, the
[Set] button does not become valid.
Note
Caution
When a PC card is ejected from the VDR/S-VDR, be sure to follow the
operation of “8.1 How to eject PC card from VDR/S-VDR”.
The PC card may be damaged and record may not be available.
PC card drive
[Import] button
To Next Page
Loading...
