[II] Sector Blank Area Creation (Make Sectors 1, 2, and 3)
Procedures 1. Transmit the radar.
2. Open the Serviceman Menu.
3. Perform the following menu open procedure to open the Sector Blank
setting menu.
2. Installation Menu
→ 3. Sector Blank
4. Press numeric keys corresponding to the desired sector creation
Make Sector N .
The selected sector blank will be made.
5. Set the starting bearing of the sector blank by operating the [EBL] dial,
and press the [ENT] key.
6. Set the ending azimuth of the sector blank by operating the [EBL] dial,
and press the [ENT] key.
4.11 TNI BLANK SETTING (TNI BLANK)
Set a sector and stop tuning operation i
n the bearing.
If a structure such as the mast is close to the radar antenna, au
tomatic tuning operation may become unstable. In this
case, set a TNI blank in the direction of the structure in order to stabilize the tuning operation.
Only one TNI blank sector can be created. The TNI blank fun
ction operates in the relative bearing with the bow as
the benchmark.
[I] TNI Blank Function On/Off (Sector)
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the TNI Blank
setting menu.
2. Installation Menu
→ 9. Next
→ 2. TNI Blank
3. Select the item 1. TNI Blank in the menu, and turn on or off the TNI
blank function.
On : The TNI blank function is operated.
Off : The TNI blank function is stopped.
4-13
To Next Page
Loading...
Need help?
General
