3ļ¼20
JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.3 OPERATION PROCEDURES
3.3.4.5 Entering latitude/longitude
Procedures
1) On the latitude/longitude input screen, sequentially click numeric
buttons to enter latitude (XXĀ°XXļ¼XXX').
For example, to enter 12Ā°34.567', sequentially click numeric buttons as follows.
ā ā ā ā ā ā
2) To make change between north latitude and south latitude, use
and .
North latitude:Left-click the button.
South latitude:Left-click the button.
3) Left-click the button.
The manually entered latitude value is determined. Then, enter the longitude value.
4) Sequentially click numeric buttons to enter longitude (XXXĀ°XXļ¼
XXX').
5) To make change between east longitude and west longitude, use
and .
East longitude: Left-click the button.
West longitude: Left-click the button.
6) Left-click the button.
The manually entered longitude value is determined.
7) To cancel input, put the cursor on and then left-click the
button.
The latitude/longitude input screen will close without reflecting the set value to the operating
state.
1 2 3 4 5 6 7
ļ¼
ļ¼
ļ¼
ļ¼
ENT
ļ¼
ļ¼
ļ¼
ļ¼
ENT
CLR
To Next Page
Loading...
Need help?
General
