JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.3 OPERATION PROCEDURES
3ļ¼19
3
3.3.4.3 Increasing or decreasing a numeric value
Procedures
1) On the numeric value input screen, sequentially left-click the
software button or located on the radar screen, and
enter a desired numeric value.
For example, when adjusting 123.0Ā° to 123.4Ā° for a bearing value, sequentially left-click the
software number keys as shown below.
ā ā ā
2) Make sure that the entered value is correct, and left-click the
button.
The set value is reflected to the operating state.
3) To stop entering a value, right-click the button.
Alternatively, left-click the button.
The numeric value input screen will close without reflecting the set value to the operating
state.
3.3.4.4 Latitude/longitude input screen
ļ¼
ļ¼
ļ¼ ļ¼ ļ¼ ļ¼
ENT
ENT
CLR
Entered latitude /
longitude
+ button (north latitude /
east longitude )
ENT buttonCLR button
- button (south latitude /
west longitude)
Numeric button
To Next Page
Loading...
Need help?
General
