1
Introduction
This guide will help you to undertand your RS64 intruder alarm control panel.
It is important to read it carefully in order to get the most from your system.
Instructions are in a step by step form with diagrams where appropriate. The RS64
has been designed to be as simple to operate as possible.
The RS64 will have been programmed by the Installation Engineer to suit your
particular installation. The system is operated from one or more Remote Keypads all
functions are processed by the main Control Unit which is accessed by the engineer
only.
RS64 has been designed to allow two different levels of access to the system. The
System Manager is the person who has overall responsibility for the system and this
means that he/she has access to more functions than the General User. To operate
your RS64 the Installation Engineer will need to provide you with at least one of two
different types of 4-digit Access Codes:
Master Access Code - used by the System Manager to operate the system and carry
out a range of programming functions:
•
Set up and modify all the User Codes.
•
Carry out Tests e.g. Sounders and Detectors.
•
Set up a Chime Suite.
•
Set up a Part Set Suite.
•
Modify the Time and Date settings.
User Access Codes - individual codes that are employed by up to nine General Users
for day-to-day operation:
•
Setting and Unsetting the Panel.
•
Omitting Zones.
•
Reset after an Alarm Activation
The System Manager also has access to the General User functions above.
To Access the Panel
Enter your 4-Digit Access Code using the numeric keys
OPEN Light will flash slowly
Proceed with Operating/Programming/Testing function
To Next Page
Loading...