6
Zone Omit
This is useful if you need to remove one or more Detection Zones on a temporary
basis if you unable to fully set the system. You can use Zone Omit on any zone
provided that the Installation Engineer has not programmed the Zone as Non Manually
Omittable (this may have been done because that particular Zone is a vital element of
the system ). The Zone Omit information is automatically discarded next time you
open the system.
To Omit Zones prior to setting the system.
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press OMIT. The OPEN light continues to flash slowly
Press number keys for zones to be omitted. The omitted Zone lights will flash slowly.
Either
Press FULL to Full Set with omitted zones
Or
Press PART to Part Set with omitted zones
Note: When using Zone Omit followed by PART, zones which would have been
automatically omitted by the Part Set Suite (see Programming section) will have to be
manually omitted.
To use Zone Omit on Day Zones.
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press OMIT. The OPEN light continues to flash slowly
Press number keys for zones to be omitted. The omitted Zone lights will flash slowly.
Press OMIT again to return to Day Mode with omitted zones.
To cancel Zone Omit on Day Zones.
Enter your 4-Digit Access Code. OPEN light starts flashing.
Press RESET
Programming
To carry out each programming function, you must first enter Menu Mode starting from
Day Mode. Once you are in Menu Mode you then enter a 2-Digit Opcode to select a
specific programming function. When that function is completed the system returns to
Menu Mode.
Menu Mode
To enter Menu Mode
Enter the 4-Digit Master Code. OPEN light start flashing
Press 00
All lights illuminate
To Next Page
Loading...