JSB RS64 - Duress Code; Keyholder Code

7
You are now in Menu Mode
Enter the 2-Digit Opcode for the function you wish to program
After programming the function
Either
Program next function by entering a new Opcode
Or
Select Opcode 99 to exit Menu Mode
All lights flash, warble tone sounds
The Control Panel is now back in Day Mode.
Note: If you get the Error Tone (a short Buzz) you have entered an incorrect Opcode.
Duress Code
To enter or change 4-digit Duress Code.
(Consult with your Installation Engineer before using this option.)
Select Opcode 02
If zone lights 1-4 flash, code exists
Press OMIT to delete the code
If zone lights 1-4 constant, enter new code
Press 4 numbered keys for new code; the lights will extinguish one at a time
Press ENTER to submit the new code
If Warble sounds, code is accepted
If Buzzer sounds, code is rejected. Try again using a different 4-Digit Code.
Keyholder Code
To enter or change 4-digit Keyholder Code.
(Consult with your Installation Engineer before using this option.)
Select Opcode 03
If zone lights 1-4 flash, code exists
Press OMIT to delete the code
If zone lights 1-4 constant, enter new code
Press 4 numbered keys for new code; the lights will extinguish one at a time
Press ENTER to submit the new code
If Warble sounds, code is accepted
If Buzzer sounds, code is rejected. Try again using a different 4-Digit Code.