WIRELESS MICROPHONE SYSTEM
13
5-2 Rack Mounting
(1) Before mount receivers onto DR-900 rack adaptor, please release any cables from the rear of
the receiver.
(2) Turn over receiver and DR-900 rack adaptor simultaneously, there are 4 threaded holes each
in the boom of receiver and rack adaptor for inserting screws.
(3) Single receiver
Insert in a receiver through the front of DR-900 until it is rmly aached to the rack, then
screw on a RP-900 to another side of the rack. (Figure 4)
(4) Dual receivers
e same way as above, put one receiver to each rack space.
(Figure 4)
To Next Page
Loading...
