JUDO QUICKSOFT-UNO 5
About this Operating Instructions
Therefore, this instruction manual must al-
ways be read by the fitter and responsible
skilled personnel/owner or operator before
installation, commissioning and mainte-
nance.
Not only the general safety notes given in
the chapter on “Manufacturer’s Specifi-
cations for Use”are to be observed, but
also the special safety notes inserted un-
der the other main items.
1.1 Symbols used
The safety notes contained in this instruction
manual are labelled with the following sym-
bols:
,
Notes directly attached to the Softener, e.g.
– Direction of flow (see Fig. 1)
– Rating plate
– Cleaning information
must always be observed and kept in a fully
legible condition.
1.2 Safety information and dan-
gers due to non-compliance
In detail, failure to observe the general dan-
ger symbols can result, for example, in the
following risks:
– Failure of important functions of the
Softener.
– Danger to persons due to electrical and
mechanical effects.
– Danger to persons and the environment
due to leaks.
Refrain from any unsafe working methods.
Failure to comply with this instruction manu-
al and the safety information can not only re-
sult in dangers for people but can also harm
the environment and the unit.
1.3 Units used
In derogation of the International System of
Units (SI = System International), the follo-
wing units are used:
ATTENTION
Notes on exist-
ing dangers
Warning, electrical voltage
Torques specified by the ma-
nufacturer.
Tips for use and other informa-
tion.
Fig. 1: Built-in rotary flange
Units Conversion
°F °F = 9/5°C + 32
bar
1 bar = 10
5
Pa = 0,1 N/mm²
1" DN 25
°e °e = 0,142 mmol/l alkaline
earth ions
To Next Page
Loading...
