6 JUDO QUICKSOFT-UNO
Intended Use
2. Intended Use
Installation and use of the Softener are each
subject to the applicable national regula-
tions.
Apart from the instruction manual and the le-
gally binding accident prevention provisions
applicable in the country and place of use,
the recognized technical regulations for safe
and proper work must also be observed.
The water to be softened must conform
to the European Drinking Water Regula-
tions!
Always contact the manufacturer/supplier
before using water with a different quality or
with additives!
This Softener is suitable for use in cold
drinking water up to maximum ambient tem-
perature of 30°C (86°F).
It is produced to state of the art standards
and the generally accepted safety regula-
tions in Germany.
The Softener may only be used as de-
scribed in the instruction manual. Any other
or further use is deemed not to be intended
use.
Additional dangers exist in case of non-in-
tended use and failure to observe the dan-
ger symbols and safety information. The
manufacturer/supplier are not liable for any
losses or damage resulting from this. The
risk is solely borne by the user.
Intended use also includes observing the in-
struction manual.
The manufacturer/supplier must always be
consulted before using the Softener outside
the use limitations given in the instruction
manual.
The Softeners are only to be used in a tech-
nically perfect condition, for their intended
use, safely and aware of the dangers and
with full observance of the instruction manu-
al!
Have any malfunctions corrected imme-
diately!
In order to be able to safely discharge the
wastewater in operation and in case of any
defect in the system, precise compliance
with the details given in the chapter on “Re-
quirements for the place of installation” is
necessary!
ATTENTION
(See chapter on “Safety information and
dangers due to non-compliance”)
The used regenerating salt is removed from
the Softener columns with the wastewater.
Therefore, it may not be used to water plants
or for similar purposes.
Take extra care if the cover has been re-
moved as moving parts are a potential dan-
ger!
The range of use for DVGW-tested Soften-
ers is specified in DIN 1988 Part 2 Para.
8.3.2. According to this standard, there are
no restrictions regarding the range of use for
these Softeners. The capacity of the Soften-
er is designed so that it can be used to partly
soften all the water for a detached or multi-
ple dwellings, as well as corresponding part
water quantities for hot water, swimming
pools, washing machines and dishwashers.
To Next Page
Loading...
Need help?
General
