34
Bartacking
Bartacking is used to reinforce the part of the seam that is
likely to ravel.
* The length of the bartack is determined by pushing the re-
verse stitch button, but it will automatically make a u-turn
when it reaches the maximum of 20 stitches.
* If the presser foot cannot be parallel to throat plate, use ller
fabric or cardboard.
Fabric
Example of use
Trousers and skirt Bag Pocket
Place the fabric under the presser foot.
10 cm
Pass the needle thread through the presser foot.
Pattern
No.
Practical 20
Presser
foot
Manual
buttonhole
presser foot (I)
2
1
Attention
Turn OFF the power switch before
replacing the presser foot.
● When the start/stop button is
pushed, the machine starts
to sew and makes a u-turn
automatically at the same
point as the rst bartack.
● When it comes to the sewing
end point, push the reverse
stitch button.
Lock
stitches
To sew a bartack of the same length again…
when the length of the rst bartack has been
memorized,
* If you want to change the memorized length of the
bar tack, please select stitch pattern again.
Turning
point
Start sewing.
Push the start/stop button and the machine starts to sew
straight stitches.
When the machine comes to the sewing end
point, push the reverse stitch button.
The machine sews lock stitches and stops.
Start/stop button
3
4
5
Starting
point
Reverse stitch button
When it comes to the turning point push the
reverse stitch button.
The machine goes back to the starting point by sewing
straight stitches and then it sews zigzag stitches to the
point where the reverse stitch button is pushed.
To Next Page
Loading...
Need help?
General
