Need help?Do you have a question about the JUKI HZL-UX8 Series and is the answer not in the manual?
General| Maximum Stitch Width | 9 mm |
|---|---|
| Maximum Stitch Length | 5 mm |
| Needle Threading | Automatic |
| LCD Screen | Yes |
| Buttonhole Styles | 16 |
| Bobbin Winding | Automatic |
| Lighting | LED |
| Foot Pressure Adjustment | Yes |
| Knee Lifter | Yes |
| Start/Stop Button | Yes |
| Needle Up/Down Button | Yes |
| Display | LCD |
| Voltage | 120V |
Details about voltage and frequency for the power switch.
Specifies the power consumption of the machine.
Lists the main unit's dimensions and weight.
Explains slide style speed control, foot controller, and safety controls.
Describes how the machine stops upon finishing sewing or in case of fault.
Specifies the maximum zigzag width.
Details how the amount of feed is changed.
Explains that pattern selection is made on the touch panel.
States the maximum number of selectable patterns.
Specifies the total number of patterns available.
Describes the automatic threading mechanism.
Explains the automatic lock stitch function for straight and other patterns.
Details the auto-return type full automatic buttonholing.
Describes storing and recalling pattern settings and patterns.
Lists various helpful messages displayed by the machine.
Lists checks for faulty thread tension.
Lists checks for stitch skipping issues.
Lists checks for thread breakage.
Lists checks for hitch stitch problems.
Lists checks for faulty material feed.
Lists checks for needle/throat plate contact.
Lists checks for faulty pattern shapes.
Lists checks for faulty auto thread trimming.
Lists checks for faulty operating noise.
Lists checks for the needle threader.
Lists checks for failure to start sewing.
Lists checks for auto presser foot lift height.
Instructions on how to remove the top cover.
Instructions on how to remove the face cover.
Instructions on how to remove the throat plate.
Procedures to adjust the needle bar height.
Adjusting the position of the presser foot lifting motor.
Steps for removing and attaching the thread trimmer unit.
Steps for removing and attaching the bobbin thread detection sensor.
How to select and access the service mode screen.
Details of items available in service mode and their descriptions.
To Next Page
