JUKI HZL-UX8 Series - JUKI HZL-UX8 Series Specifications; Power switch details; Power consumption; Dimensions and weight

– 1 –
(1) Power switch
• 220-240V AC common to 50/60 Hz
• 120V AC common to 60 Hz
(2) Power consumption
• 90 W
(3) Dimensions and weight
• Dimensions Main unit: 602 (width) × 264 (depth) × 310 (height) (mm)
• Weight Main unit: 14.9 kg
(4) Revolution control
• Slide style speed control
Straight stitch 80 to 1,050 sti/min (SPM)
Pattern stitch 80 to 750 sti/min (SPM)
Reverse stitch 80 to 1,050 sti/min (SPM)
 (Sewingspeedotherthanthespeciedrangecanbesetoptionally.)
80 to 1,050 sti/min (SPM) (when the speed controller is used.)
Bobbinwinding 1,500to3,000sti/min(SPM)
Low-speed start 80 to 110 sti/min (SPM) (approx. 1 second only when the power switch is turned ON.)
• Foot controller
Evenwhenthefootcontrollerisused,thespeedcontrolfunctionbymeansofthesliderise󰀨ective.
Tostopthemachine,eitherreleasethefootcontrollerorpressstart/stopbutton.
Thenumberofrevolutionsiscontrolledinthewaysamewiththecaseoftheslidespeedcontrol.
Toe-uppedalingfunctioncanbesetoptionally.
• Safety control
When the motor shaft of the sewing machine is accidentally constrained, the power supply to the motor is
stopped within two seconds.
Whenthemotorisoverheated,thebuiltinthermalswitchstopsthepowertothemotor.
Notethatthemachinecanberestartedoncethemotorspontaneouslycoolsdown.
(5) Stop position
•Uponnishingsewing,themachinestopsaccordingtothepresetneedlestopposition(withitsneedleupor
down).
•Uponnishingreversestitching,themachinestopswithitsneedledown.
• Needle moves down when the machine has preset so that the needle stops at its up position and needle up/
downbuttonispressed.
• Needle moves up when the machine has preset so that the needle stops at its down position and needle up/
downbuttonispressed.
• In the case of fault, the machine stops immediately (stop position varies).
(6) Zigzag width
• Max. 7 mm depending on the pattern selected
(7) Amount of feed
•Theamountoffeedischangedinincrementsof0.2mmbythestitchlengthadjustingdial(orbutton).
 (Fortheparallelpartsofabuttonholeandsatinstitches,theamountfeedischangedinincrementsof0.1mm.)
Default setting: 2.4 mm (for straight stitching)
[1] Specications of HZL-UX8