47
Pattern
No.
Practical 00
Presser
foot
Edge sewing
presser foot (R)
This is for quilting the edge of patchworks and appliqués.
The machine will sew the lower (thinner) side of the fabric lay-
ers. As a result, the stitches will not be noticeable and have
an effect to make the design look three dimensional or em-
phasized.
Stitch in ditch quilting
1
Optional accessory part
2
Put the guide of the presser foot along
with the crease and sew.
The needle enters behind the guide, so that the
edge of the crease can be sewn.
* If the desired points can not be sewn, adjust
the needle position.
Needle position change: refer to page 24
Curved concealed quilting
Use manual buttonhole presser foot (I) or the open toe
presser foot (O).
Sew curves by lifting the presser foot and changing the
direction very often.
Also this can be done by free motion with the quilt press-
er foot. (Refer to page 48.)
Attention
Turn OFF the power switch before
replacing the presser foot.
Put the top layer of fabric with patchwork and/
or appliqués, quilting cotton and bottom layer of
fabric together by pin or basting stitches.
Pattern
No.
Practical 00
Presser
foot
Walking foot (N)
Quilting (straight stitch)
Optional accessory part
Attention
Turn OFF the power switch before
replacing the presser foot.
Quilting is the process of sewing the top layer of fabric, with
quilting cotton in between and a bottom layer of fabric under-
neath. By using the walking foot, the machine feeds both top
and bottom fabrics together at the same time, so fabric shift-
ing is eliminated.
1
Setscrew for presser
foot holder
Presser bar
Presser foot holder
2
3
Setscrew for presser foot
Actuating lever
Needle clamp
Presser bar
Assembling point
Put top layer of fabric with patchwork and/or
appliqué, quilting cotton and bottom fabric together
by using pin or basting stitches.
Place your hands to both sides of the presser
foot and sew by pulling the fabrics apart.
* Sew with slow to medium sewing speed.
Assemble the walking foot.
Raise the presser bar. Loosen the setscrew for presser
foot holder and remove the presser foot holder. (Refer to
page 12) Set the actuating lever on the needle clamp and
insert the assembling point to the presser bar and tighten
the setscrew for presser foot.
To Next Page
Loading...
Need help?
General
