– 13 –
❺
❻
❶
❷ ❸ ❹
❺
❻
❶
❷ ❸ ❹
(2) Releasing procedure of the grease-up warning for SC-920
When the time of grease-up has
come, screen display of LED
❺
on
the left-hand gure becomes "E220".
After performing grease-up, release
the warning following the procedure
below.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
1) Turn OFF the power to the unit.
2) Pressing switch
❹
, turn ON
the power to the unit.
3) When the screen is displayed,
keep switch
❹
held pressed
for three seconds until the buzzer
sounds twice.
4) Set the setting No.
❻
to "118".
When you want to advance the
setting No.
❻
, press switch
❷
to advance the setting No.
❻
When you want to return the set-
ting No.
❻
, press switch
❶
to return the setting No.
❻
❺
❻
❶
❷ ❸ ❹
Keep pressing switch
❷
or switch
❶
, and the setting No.
❻
will advance (return)
continuously. If the setting No.
❻
is moved forward (or backward), the previous (or subsequent)
content of the setting is conrmed. Be careful when the content of a setting is changed (when
the up / down
switch is touched).
To Next Page
Loading...
