– 5 –
3) Mount rubber hinge seats
❼
on the table and x the
table with nails.
Insert hinge
❻
into the machine main body. Engage the hing-
es with rubber hinge seats
❼
mounted on the table. Then,
put the machine head down on the machine head cushions
❽
which are located at the four corners of the table.
3-2. Installation of the sewing machine
1) The under cover should rest on the four corners
of the machine table groove.
2) Fix two rubber seats
❶
on side
A
(operator’s
side) using nails
❷
as illustrated above. Fix two
cushion seats
❸
on side
B
(hinged side) using a
rubber-based adhesive. Then place under cover
❹
on the xed seats.
(1) Installing the under cover
5) Detach inlet port
for circulation which is xed on the feed box cover. Insert the inlet port into lter
until it will go no further without fail and place them in opening
C
.
Place urethan lter
on
D
, and place lter
of thin plate type (small mesh plate) on it.
❶
❷
❹
❸
A
B
22.5mm
❶
❸
❶
❸
18.5mm
❻
❻
❼
❾
❽
❼
4) Attach head support rod
❾
to the table.
C
D
Circulation trouble may occur unless inlet port
for circulation is securely inserted into ler
until it goes no further.
To Next Page
Loading...
