Need help?Do you have a question about the JUKI LU-1508N and is the answer not in the manual?
General| Type | Lockstitch sewing machine |
|---|---|
| Max Stitch Length | 5 mm |
| Hook | Full Rotary Hook |
| Motor Type | Servo motor |
| Needle | Size 9 to 18 |
Explains the different levels of danger associated with machine operation.
Illustrates and explains the meaning of various warning symbols and labels.
Covers basic safety measures, operator training, and general prohibitions for safe machine use.
Details power-off procedures for threading, part replacement, repair, and leaving the machine.
Identifies the symbols used to denote hazards and points requiring special attention.
Details machine models (LU-1508N/NH, LU-1509N/NH) and their max speeds/stitch lengths.
Specifies needle types, thread sizes, hook type, and recommended lubricating oil.
Provides workplace noise levels measured according to DIN standards.
Checklist for initial operation including cleaning, oiling, voltage, and power connection.
Instructions for attaching hinge seats, support rubbers, and the oil pan to the table.
Guide on adjusting belt tension by motor height to achieve specific sag.
Step-by-step guide on lubricating various machine parts, including oil levels.
Detailed instructions for threading the upper thread through the machine head components.
Guides for adjusting upper and lower thread tension for balanced stitches.
Instructions for aligning the needle with the hook for proper stitch formation.
Discusses causes like rough thread paths, high tension, or incorrect timing, and their solutions.
Covers causes for skipped stitches such as incorrect needle/hook timing or low presser foot pressure.
Addresses causes for loose stitches like improper bobbin threading or weak bobbin tension.
To Next Page
