3.
Sewing
speed
As previously mentioned, the speed of this machine at the maximum
zigzag width of throw of 12m/m(15/32") is ,1700 stitches per minute and
when the zigzag width is less than 10m/m{25/64''), it can embrioder at the
speed of 2,000 stitches per minute.
The rotation of the machine determines the sewing speed. The number
of rotation varies with the electric cycle and the diameter of the motor
pulley.
(Refer
to
Table)
Speed
Cycle
Motor
pulley
1700
50-0
MTK-P0075000
60-O
MTK-P0065000
2000
50-O
MTK-P0095000
60-O
MTK-PV080000
Unless otherwise requested, this machine's motor pulley is of l,700s.p.m.
type but if a different speed is desired, please order our agents or exclusive
dealers.
The
power of the clutch motor attached to this machine is a single
phase 200
Watt
(1/4HP), so to ensure a long life of this machine, it is
highly
recommended
to
use
a
motor
pulley
of
l,700s.p.m.
speed.
^
4.
Installing
the
machine
(A)
Correct
height
Install
the
machine
on
the
table
and
shake
the
machine
a
little
to
see
if it's uniformly even.
When
all
the
corners
are
even it should not move
but
if any one of
the
corners is uneven, it will rattle.
When
it rattles, nail in a thin felt cushion pad B (B-8208-012-000) (four
of which
are
in
the
accessories box together with nails),
under
the low
corner
and
make
the
height
even. Be
sure
to
nail
in
the
head
of
the
nail
deep inside
the
pad
until it sinks into it.
Unless
the
height of the machine is installed evenly, it will not rotate
— 3 —
To Next Page
Loading...
