JUKI MO-2414 User Manual

8E240430tsoA
No.04
MODEL
MO.24O4
l.NEEDLE
OVEREDGER
MODEL
MO-241
4
2.NEEDLE
OVEREDGER
MODEL
MO
-241
6
SAFETY
STITCHER
InsrnucTtoN
Congratulations on'
your
purchase
of JUKI
MO-2400
Series machines.
Please read this Instruction Book
carefully
before
using these units in order
to
get
the most out of
them and to enjoy using them for a long
time.
[For
ttre
first
one
month or
so, operate the
I
lmachine
at about
80% speed of its
max.
I
[sewing
speed.
J
BEFORE
OPERATION
Cloth
plate
cover
1. Do
not hold
the
cloth
plate
cover when
carrying
the
machine.
3.
Apply
two
or three
drops
of oil to
the needle bar
guide
and
upper
looper
guide
when
operating
the
machine for
the
first
time
after setup
or
after a long
period
of disuse.
A"iewed
from
toP)
oir
sause
sz
f&
2. lf
the
red color is'not
seen when
you
look down
or
sideward
at the
oil
gauge,
supply oil in
accordance with
"6.
Lubrication".
Running direction
4.
The
correct machine running direction
is
such that the handwheel
turns clock-
wise
as viewed
from
the handwheel's
side.
Never
run the machine in the
reverse
direction.
CAUTIONS IN
OPERATION
1.
Do
not
put
your
hand under the
needle
whijn
you
turn
on the
power
switch.
4. Never bring
your
fingers
or hair
close to, or
place
anything
on the
handwheel,
V-belt, bobbin
winder wheel or motor
during operation.
lt
may lead
to serious
personal
injuries.
5.
lf
your
machine is
provided
with a belt cover, finger
guard
and
eye
guard,
never operate
your
machine
with
any of
them removed.
2. Do not
put your
hand into the
face
plate
section
while
the
machine is
running.
3. Be sure
to turn
off the
power
switch before
you
remove the
V
belt.
-l-

JUKI MO-2414 Specifications

General

Type	Overlock
Differential Feed	0.7-2.0
Differential Feed Ratio	0.7 - 2.0
Stitch Type	504, 514
Needle Size	#11-#14
Motor Power	90 W

Summary

Before Operation Guide

Operation Cautions and Safety

Frame Support Plate Installation

Lubrication Procedures

Needle Color Lubrication

Procedure for lubricating the needle cooler with silicone oil.

Needle Installation

Machine Threading Guide

Thread Tension Adjustment

Presser Foot Pressure and Lifter

Stitch Length Adjustment

Differential Feed Mechanism

Looper Setting and Clearance

Lower Looper Setting

Setting clearance for the lower looper relative to the needle.

Upper Looper Setting

Setting clearance for the upper looper relative to the needle.

Double-Chain Looper Setting

Presser Foot and Feed Dog Adjustments

Presser Foot Contact Adjustment

Feed Dog Height Adjustment

Knives and Overedge Width Adjustment

Lower Knife Height Adjustment

Adjusting the height of the lower knife relative to the throat plate.

Upper Knife Height Adjustment

Overedge Width Setting

Needle Guard Positioning

Needle Guards for 1 & 2-Needle Overedgers

Needle Guards for Safety Stitchers

Stitch Failures and Corrective Measures