Do you have a question about the JUKI MO-51EN and is the answer not in the manual?
Type | Overlock |
---|---|
Stitch Type | Overlock, Rolled Hem, Flatlock |
Differential Feed | Yes |
Differential Feed Ratio | 0.7 - 2.0 |
Foot Control | Yes |
Needle Type | DB x 1 |
Thread Tension | Adjustable |
Presser Foot Lift | Up to 5 mm |
Motor Power | 90 W |
Max Stitch Width | 7 mm |
Max Stitch Length | 4.0 mm |
Needle Position | Left |
Power Requirements | AC 110-120V / AC 220-240V |
Number of Threads | 3 or 4 |
Number of Needles | 1 or 2 |
Warnings related to electric shock risks.
Warnings related to burns, fire, electric shock, or injury.
Instructions for maintaining double-insulated appliances.
Reminder to keep the manual for future reference.
Lists all included accessories and their purpose.
Instructions on how to open and close the accessory storage box.
How to open and close the looper cover for access.
How to install and use the waste collector for fabric scraps.
Instructions for opening and closing the cloth plate cover.
Connecting the foot control pedal to the machine and power outlet.
How sewing speed is adjusted using the foot control.
Steps to raise and secure the thread stand.
How to use anti-vibration cones and nets with thread spools.
Location and function of the power and light switch.
How the handwheel operates.
How to raise the presser foot.
Steps to remove and attach presser foot soles.
Instructions for correctly inserting needles into the machine.
How to raise the upper knife for operation.
Initial steps before threading the machine.
Step-by-step guide for threading the upper looper with blue thread.
Step-by-step guide for threading the lower looper with red thread.
Step-by-step guide for threading the right needle with green thread.
Step-by-step guide for threading the left needle with yellow thread.
Final steps after all threads are in place.
Performing a test run with fabric to check stitch and tension.
How to evaluate the quality of the test seam.
How to adjust the stitch length from 1 to 4 mm.
How to adjust the cutting width based on fabric type.
Specific steps to adjust the knife position for cutting width.
Selecting needle plates for regular or rolled hems.
Using differential feed to stretch fabric and prevent puckering.
Using differential feed to prevent waving or gather fabric.
Important note on setting differential feed to N when not in use.
Using differential feed to gather a single layer of fabric.
How to perform a 3-thread overlock seam.
How to perform a 3-thread roll hem.
How to unpick seams by cutting threads.
Steps to replace the machine's light bulb.
How to clean dust/fluff and lubricate moving parts.