ENGLISH
112
Tools
Most people already have the tools needed for
installation: spirit level, pencil, crosshead
screwdriver, drill, 8 mm. concrete drill bit,
detection drill, square, tape measure or ruler,
tape width 65 mm, hole saw about 80 mm
(deviation in size may occur), knife and two
adjustable spanners or pliers (and possibly
torque wrench).
Indoor unit & control panel
It is recommended to install the indoor unit next to or
near the boiler room. Consult a plumber about the best
location for the unit to ensure optimal installation to
your existing hydronic system. Flexible hoses are
recommended for plumbing connections for the indoor
unit.
The control panel can be placed anywhere in the
house. However, if you want to control the unit at room
temperature, we recommend placing it in the room
where it is most important to maintain the required
temperature.
To Next Page
