HE / SE
67
Disturbances that are not indicated.
The electronic pump motor is overload-protected by an electronic current
limiter. If viscosity of the bath fluid is or becomes too high, the motor stops
running.
Before exchanging the fuses, turn off the mains power switch and disconnect the
power plug from the mains socket!
Only use fine fuses with a nominal value as specified.
Fuses:
The mains fuses on the rear of the unit may easily be exchanged as
shown on the left.
Fine fuses (16)– T 16 A
Example:
G-fuse insert SPT
T16A 5x20mm
G- fuse insert
T10,0A 5x20 mm
To Next Page
