O P E R A T I O N M A N U A L
INTRODUCTION
The
Jumbo Touch Panel Remote Control can operate up to five types of devices: TVs, VCRs,
DVD players, Cable/Satellite set-top boxes, DVRs and CD players.
See the diagram on Page 2 to familiarize yourself with the features of this remote control.
You may need to review the operating manuals of your original remotes to refresh yourself
on the functions of those units.
BATTERY INSTALLATION
1. Remove the cover from the battery compartment, which is located on the back of the unit.
2. Insert four “AAA” size alkaline batteries (not included) according to the diagram inside the
battery compartment and replace the battery compartment cover.
3. Press the ON/OFF button, the LED should illuminate; if it doesn’t, replace the batteries
Requires 4 “AAA” batteries (not included).
Jumbo
Touch Panel Remote
BATTERY WARNING:
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (Nickel Metal Hydride).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult supervision (if removable).
• Exhausted batteries should be removed immediately and must be recycled or disposed of properly
according to state or local government ordinances and regulations.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (see diagram).
• Do not dispose batteries in a fire, batteries may leak or explode.
and try again.
To Next Page
General