5
Operate manual
Auto measure the HR
1.Turn on
Press
For 2 seconds ,the equipment will turn on and self-check,when the
HR appear “---”,,the self-check is finish and get into use,model 1 is default.
2.Detect the FHR
Put the Gel on the detect position of the pregnant woman’sabdomen ,then
press the probe ensure it is good connected ,when the probe is on the right
position,you can hear the fetal heart beat,wait until the voice is clearly,the LCD
will show the right FHR.
3.Adjust the volume
The volume will increase,reduce when you press the
During the FHR is showed,if the volume is in maximum or minimum,continue to
press it will useless ,and without voice.
4.Turn off
When you do not use it, press for 2 seconds to turn off it. The equipment will auto
turn off if it is no signal,press to restart it.
Handmade measure HR
1.Turn on the equipment and press ,choose the model 3--handmade
measure HR
2.Detect the FHR
Put the Gel on the detect position of the pregnant woman’sabdomen ,then
press the probe ensure it is good connected ,when the probe is on the right
position,you can hear the fetal heart beat,press or According to the voice
from the Loudspeaker 10 times later,press or again,the LCD will show the
average FHR,repeatit if you want to continue it
,
.
3.Change to auto measure.
Press can change to auto measure model.
4.Turn off
When you do not use it, press for 2 seconds to turn off it. The equipment
will autoturn off if it is no signal,press to restart it.
To Next Page
Loading...
