JUNCTEK
JDS8000 Series User’s Manual
Load: Click Load, the“Load”pop-up box will pop out, input the corresponding
storage location, and the parameters of the storage location can be loaded. As
shown in Figure 3-9-38 below.
Save: Click Save, the“Save”pop-up box will pop out, input the location to be
stored, and the parameters can be stored in the storage location. As shown in
Figure 3-9-39 below.
Clear Memory: Click Clear Memory, the“Clear Memory”pop-up box will pop out,
input the parameter storage location to be cleared, and the parameters of the
storage location can be cleared and restored to default. As shown in Figure
3-9-40 below.
Arbitrary Waveform Editing: Click Arbitrary Wave Editing, the“Arbitrary Wave
Editing”pop-up box will pop out, and you can freely edit arbitrary waveforms
and write them into the machine. As shown in Figure 3-9-41 below.
Set synchronization: Click set synchronization, waveform synchronization,
frequency synchronization, amplitude synchronization, offset synchronization,
duty cycle synchronization, and external synchronization can be set. As shown
in Figure 3-9-42 below.
Firmware upgrade: Click on the firmware upgrade, the "Input firmware code"
pop-up window will pop up, input the corresponding firmware code, the default
is 0 0 0, the instrument will automatically upgrade the firmware, please wait
patiently during the upgrade process, do not do other operations, "Success"
indicates that the firmware upgrade is successful. As shown in Figure 3-9-43.
As shown in Figure 3-9-43.
Parameter fine-adjusting: Click parameter fine-adjusting to set frequency
fine-adjusting, CH1 amplitude fine-adjusting, and CH2 amplitude fine-adjusting.
As shown in Figure 3-9-44.
Power-on automatic output: Click power-on automatic output, you can set the
default output of the instrument when it is powered on. As shown in Figure
3-9-45.
To Next Page
Loading...