￭ Fit device in appliance box; terminals must be at the bottom.
￭ Fit the frame, central plate and control knob.
￭ Switch on mains voltage.
7.1 Commissioning
Setting control behaviour
Factory setting: pulse width modulated control (PWM)
This setting can be used with most heating systems without adaptation.
Changing the settings
￭ Press the control knob for longer than 20 seconds.
The LED flashes
green
for PWM control and
green/blue
for 2-point control.
￭ Press the control knob briefly: The control behaviour is changed.
￭ Press the control knob for longer than one second.
The current control behaviour is saved and the setting mode is exited automat-
ically.
After approx. 2 minutes without any operation the menu is exited without sav-
ing.
Setting the temperature limits
The temperature control has a setting range from 5 to 50 °C. The adjustment rings in
the central plate can be used to limit the temperature setting range.
Floor thermostat
7 / 9
82404903 16.09.2022
J0082404903
To Next Page
Loading...