4.6 Check wheel attachment and wear
Z
Replace the wheels if the wear limit (107) has been reached.
Z
The wheel nuts on the drive wheel must be retightened in accordance with the
maintenance intervals indicated in the maintenance checklist, see page 195.
Tightening the wheel nuts
Requirements
– Prepare the truck for maintenance and repairs, see page 179.
Tools and Material Required
– Torque wrench
Procedure
• Position the drive wheel (106) so that the wheel nuts (108) can be pulled through
the hole (105).
• Tighten all the wheel nuts (108) through the hole (105) in the impact buffer with
the socket wrench.
To do this, tighten the wheel nuts in the prescribed order.
• First of all tighten to 10 Nm.
• and then to 150 Nm.
The wheel nuts have now been tightened.
187
04.19 en-GB
To Next Page
Loading...
