101
11.14 EN
6.2.2 Starting procedure for the TFG
DANGER!
Risk of escaping liquid gas if the truck does not start
XNote the safety regulations governing the handling of liquid gas
(see "Safety regulations for handling diesel fuel and LPG" on page 49)
XClose the gas bottle shut-off valve.
XSet the key switch to "O"
XNotify your superior.
Procedure
•
• Slowly open the shut-off valve on the LPG bottles, see "LPG
bottles" on page 54.
• Insert the key in the key switch (88) and turn it to the “2”
position.
•
• All the indicators light up briefly to test operation.
Z All the indicators except for the engine oil pressure
display, parking brake indicator, indicator lamp for neutral
position and battery control light (85) should go out after
a short while. If not, abandon the starting procedure and
rectify the fault.
•
• Select the LPG supply by pressing the (71)
switch, see "Operating the Twin Bottle System
and Liquid Gas Tank" on page 56.
• Turn the key to position "3".
Z Apply the starter for no more than 15 seconds
without interruption. The truck is equipped with
an immobiliser which prevents it from starting
again while the engine is running.
• Release the key as soon as the engine starts. The key automatically reverts to the
"2" position.
Z All indicators lights except for neutral position and parking brake should go out as
soon as the engine starts. If not, stop the engine immediately and rectify the fault.
Truck is operational.
3
To Next Page
Loading...
Need help?
General
