11.14 EN
122
Safety instructions for sideshifter and fork positioner attachments
WARNING!
Restricted visibility and reduced tilt resistance can cause accidents
When using sideshifters and fork positioners, the change in centre of gravity can
result in reduced lateral tilt resistance and accidents. Note that this affects visibility as
well.
X
Adapt the travel speeds to the visibility and load.
X
Make sure you have sufficient visibility when reversing.
Safety instructions for clamping attachments (e.g. baling clamps, barrel
clamps, grabs etc.)
WARNING!
Falling loads can cause accidents
This can result in malfunctions and the load can fall accidentally.
XClamping attachments may only be added to trucks which have a button to enable
additional hydraulic functions.
XClamping attachments must only be operated on trucks will auxiliary hydraulics
ZH2 or ZH3.
XWhen connecting the attachment make sure that the hydraulic lines of the
attachment are connected to the right ports, see "Fitting additional attachments" on
page 126.
Safety instructions for rotary attachments
WARNING!
A non-centred load centre of gravity can result in accidents
When using rotary devices and non-centred loads, the centre of gravity can be
displaced from the centre with a high risk of accidents.
XAdapt the travel speed to the load.
XLift the load from the centre.
Safety instructions for telescopic attachments
WARNING!
Accident risk from increased tipover hazard and reduced residual capacity
There is a greater risk of tipover with extended telescopic attachments.
XDo not exceed the maximum loads specified on the capacity plate.
XOnly use the telescopic function for stacking and retrieving.
XRetract the telescopic attachment fully during transport.
XAdapt the travel speed to changed load centre of gravity.