149
11.14 EN
9.3.3 Starting aid
WARNING!
Danger from overheating
X
Only use an ISO 6722 battery jump lead
with fully insulated terminal pliers and a
lead diameter of at least 50 mm².
Procedure
• Open the right side window completely.
• see "Tilting the Cab" on page 167Tilt the
cab of the truck until the retaining device
(210) is locked in position,
• First connect the positive terminal of the
feeder battery to the positive terminal of
the truck battery (211) with the red lead.
• Connect the negative terminal of the
feeder battery and the earth point of the
crane eye on the engine with the black
lead.
• Use a ladder to change the truck height
and reach through the open side window
to start the truck engine with the ignition
key with the cab fully tilted.
• Start the engine as normal.
• When the engine has started first remove
the negative lead followed by the positive
lead
Z If the starter motor does not switch on the engine after connecting the battery
terminals, check that the battery terminal clips are positioned correctly.
To Next Page
Loading...
Need help?
General
