EasyManuals Logo

Jungheinrich TFG 670 User Manual

Jungheinrich TFG 670
221 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
175
11.14 EN
4.9.1 Checking the hydraulic oil level
Requirements
Park the truck on a level surface.
Start the engine and fully raise and lower
the mast once.
Switch off the engine.
Procedure
Remove the hydraulic oil dipstick (242)
from the hole, wipe it with a clean cloth and
insert it fully again.
Remove the hydraulic oil dipstick and
check the level of the hydraulic oil.
Z For cold oil: the oil level should lie between
the MIN and MAX markings.
For hot oil: the oil should lie just above the
MAX marking.
The difference between MIN and MAX is
approximately 10 litres.
Add hydraulic oil if necessary.
Repeat the test.
When the oil level is correct, fully insert the hydraulic oil dipstick (242) again.
MIN
MAX
242

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jungheinrich TFG 670 and is the answer not in the manual?

Jungheinrich TFG 670 Specifications

General IconGeneral
BrandJungheinrich
ModelTFG 670
CategoryFront End Loaders
LanguageEnglish

Related product manuals