Juniper E320 User Manual

JUNOSe 7.2.x Policy Management Configuration Guide
14 ! Creating Classifier Control Lists
! Use the destinationQualifier option to specify a single TCP or UDP port or range
of ports, an ICMP code and optional type, or an IGMP type. The
destinationQualifier option is composed of the following suboptions:
! portNumber—Single port number or the beginning of a range of port
numbers (TCP and UDP only)
! portOperator—One of the following (TCP and UDP only):
" eq—Equal to
" lt—Less than
" gt—Greater than
" neq—Not equal to
" range—Range of ports
! toPortNumber—End of a range of port numbers (TCP and UDP only)
! icmpType—ICMP message type (ICMP only)
! icmpCode—ICMP message code (ICMP only)
! igmpType—IGMP message type (IGMP only)
For example, the following command matches packets with source address
198.168.30.100 and ICMP type 2 and code 10:
host1(config)#ip classifier-list YourListName icmp host 192.168.30.100 any 2
10
! Use the tcp-flags keyword and a logical equation (a quotation-enclosed string
using ! for NOT, & for AND) to match one or more of the following TCP flags:
ack, fin, psh, rst, syn, urg. For example:
host1(config)#ip classifier-list telnetConnects tcp 192.168.10.0 0.0.0.255 host
10.10.10.10 eq 23 tcp-flags "syn & !ack"
! Use the ip-flags keyword and a logical equation (a quotation-enclosed string
using ! for NOT, & for AND) to match one or more of the following IP flags:
dont-fragment, more-fragments, reserved. For example:
host1(config)#ip classifier-list dontFragment ip any any ip-flags "dont-fragment"
! For both IP flags and TCP flags, if you specify only a single flag, the logical
equation does not require quotation marks.
! Use the ip-frag-offset keyword and the eq or gt operator to match an IP
fragmentation offset equal to 0, 1, or greater than 1.
For example, the following commands configure a policy to filter fragmentation
offsets equal to 1:
host1(config)#ip classifier-list fragOffsetAttack ip any host 10.10.10.10
ip-frag-offset eq 1
host1(config)#ip policy-list dosProtect
host1(config-policy-list)#filter classifier-group fragOffsetAttack
host1(config-policy-list)#forward
! Use the traffic-class keyword to match packets with a traffic class that you
defined using the traffic-class command.

Juniper E320 Specifications

General

Brand	Juniper
Model	E320
Category	Network Router
Language	English