Juniper E320

Merging Policies ! 53
Chapter 2: Creating Policies
Virtual-router: default
List:
next-hop 20.1.1.1, order 100, rule 3 (active)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy mpl_5
Administrative state: enable
Reference count: 1
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
6. Show configuration.
host1#show conf
! Configuration script being generated on TUE APR 26 2005 17:33:01 UTC
! Juniper Edge Routing Switch ERX-1440
! Version: 9.9.9 development-4.0 (April 4, 2005 15:39)
! Copyright (c) 1999-2005 Juniper Networks, Inc. All rights reserved.
!
! Commands displayed are limited to those available at privilege level 15
!
…
interface atm 5/0.1
ip policy input p1 statistics enabled merge
ip policy input p2 statistics enabled merge
exit
…
…
ip policy-list p1
classifier-group C2 precedence 10
filter