Creating Policy Lists ! 23
Chapter 2: Creating Policies
3. Add a rule that specifies a group of forwarding solutions based on classifier list
ipCLACL10.
host1(config-policy-list-classifier-group)#forward next-hop 192.0.2.12 order 10
host1(config-policy-list-classifier-group)#forward next-hop 192.0.100.109 order 20
host1(config-policy-list-classifier-group)#forward next-hop 192.120.17.5 order 30
host1(config-policy-list-classifier-group)#forward interface ip 3/1 order 40
4. Add a rule that sets a ToS byte value of 125 for packets based on classifier list
ipCLACL10.
host1(config-policy-list-classifier-group)#mark tos 125
5. Add a rule that uses rate-limit profile ipRLP25.
host1(config-policy-list-classifier-group)#rate-limit-profile ipRLP25
6. Exit Classifier Group Configuration mode for ipCLACL10, then create a new
classification group for classifier list ipCLACL20. Add a rule that filters packets
based on classifier list ipCLACL20.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#classifier-group ipCLACL20 precedence 125
host1(config-policy-list-classifier-group)#filter
7. Exit Policy List Configuration mode to save the configuration.
host1(config-policy-list-classifier-group)#exit
host1(config-policy-list)#exit
host1(config)#
8. Display the policy list.
host1#show policy-list routeForABCCorp
Policy Table
------ -----
IP Policy routeForABCCorp
Administrative state: enable
Reference count: 0
Classifier control list: ipCLACL10, precedence 75
forward
Virtual-router: default
List:
next-hop 192.0.2.12, order 10, rule 2 (active)
next-hop 192.0.100.109, order 20, rule 3 (reachable)
next-hop 192.120.17.5, order 30, rule 4 (reachable)
interface ip3/1, order 40, rule 5
mark tos 125
rate-limit-profile ipRLP25
Classifier control list: ipCLACL20, precedence 125
filter
NOTE: Commands that you issue in Policy Configuration mode do not take effect
until you exit from that mode.
To Next Page
Loading...
Need help?
General
