Juniper E320 User Manual

JUNOSe 7.2.x Policy Management Configuration Guide
62 ! Merging Policies
Reference count: 1
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.2 output policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
17. Detach p3 from atm 5/0.1.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p3
host1(config-subif)#exit
18. Detach p1 from atm 5/0.2. Merge policy mpl_5 is detached and deleted and
only p2 is now attached.
host1(config)#interface atm 5/0.2
host1(config-subif)#no ip policy output p1
host1(config-subif)#exit
19. Detach p2 from atm 5/0.2.
host1(config)#interface atm 5/0.2
host1(config-subif)#no ip policy output p2
host1(config-subif)#exit
20. Display policies to verify that no merge policies exist and that all other policies
have a 0 reference count because they are not attached anywhere.
host1#show policy-list
Policy Table
------ -----
IP Policy p1
Administrative state: enable
Reference count: 0
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)

Juniper E320 Specifications

General

Brand	Juniper
Model	E320
Category	Network Router
Language	English