Figure 68: Set Up Quick Configuration Page
Before you configure the router, gather the information described in “Before You
Begin” on page 134.
To configure basic settings with J-Web Quick Configuration:
1.
If you have not already done so, connect a management device to the ge-0/0/0
interface on port 0/0. For instructions, see “Connecting to the J-Web
Interface” on page 135.
2. If the Set Up Quick Configuration page is not displayed, select
Configuration>Quick Configuration >Set Up.
3. Enter information into the Set Up Quick Configuration page, as described in
Table 55 on page 143.
4. Click one of the following buttons:
■ To apply the configuration and stay in the Set Up Quick Configuration page,
click Apply.
■ To apply the configuration and return to the Quick Configuration page, click
OK.
142 ■ Configuring Basic Settings with J-Web Quick Configuration
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
To Next Page
Loading...
Need help?
General
