user@host# set chassis fpc 2 offline
If the power and heat tokens no longer exceed the maximum, the PIMs that
were placed offline by J-series power management are brought online
automatically.
■
Use the set chassis disable_power_management command to disable J-series
power management:
user@host# set chassis disable_power_management
CAUTION: Use extreme caution when disabling J-series power management. To
prevent equipment damage, do not install a combination of PIMs that exceeds the
power or heat capacity of your router when J-series power management is disabled.
The set chassis disable_power_management command brings the offline
PIMs online automatically.
To reenable J-series power management, remove the configuration statement. For
detailed information about the set chassis fpc offline and set chassis
disable_power_management configuration statements, see the JUNOS System Basics
Configuration Guide.
Contacting the Juniper Networks Technical Assistance Center
If you need assistance while troubleshooting a Services Router, open a support case
using the Case Manager link at http://www.juniper.net/support/, or call 1-888-314-JTAC
(within the United States) or 1-408-745-9500 (from outside the United States). For
more information, see “Contacting Customer Support and Returning
Hardware” on page 215.
214 ■ Contacting the Juniper Networks Technical Assistance Center
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
To Next Page
Loading...
Need help?
General
