Juniper LTE Mini-PIM - Page 32

Juniper LTE Mini-PIM

32 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

Reference Signal Receiving Power (RSRP): -97

Reference Signal Receiving Quality (RSRQ): -16

Signal to Interference-plus-Noise Ratio (SiNR): 0

Signal Noise Ratio (SNR): 0

Energy per Chip to Interference (ECIO): 0

RELATED DOCUMENTATION

Upgrading the Mini-PIM Firmware Using the CLI | 17

22

Table of Contents

Default Chapter3
- Default Chapter3
  - Table of Contents3
- About the Documentation4
1 Overview11
2 Installation18
- LTE Mini-PIM Installation and Configuration19
  - Installing the LTE Mini-PIM in a SRX Series Services Gateway19
  - Configuring the LTE Mini-PIM on SRX Series Devices24
    - Configuring the LTE Mini-PIM24
    - Configuring a Static Route on the Dialer Interface25
- LTE Mini-PIM Firmware Upgrade27
  - Upgrading the Mini-PIM Firmware Using the CLI27
  - Upgrading the Modem Firmware by Using OTA Upgrade30