•
When removing or installing an electrical component, always place it component-side
up on a flat antistatic surface or in an electrostatic bag.
•
When you install the router, always make the ground connection first and disconnect
it last.
•
Wire the DC power supply using the appropriate lugs.
•
Do not work on the system or connect or disconnect cables during electrical storms.
•
Before working on equipment that is connected to power lines, remove jewelry, including
rings, necklaces, and watches. Metal objects heat up when connected to power and
ground and can cause serious burns or become welded to the terminals.
•
Failure to observe these safety warnings can result in serious physical injury.
•
AC power cable warning (Japan):
WARNING: The attached power cable is only for this product. Do not use
the cable for another product.
Compliance Statements for NEBS
•
The equipment is suitable for installation as part of the Common Bonding Network
(CBN).
•
The equipment is suitable for installation in locations where the National Electrical
Code (NEC) applies.
•
The battery return connection is to be treated as an isolated DC return (i.e. DC-I), as
defined in GR-1089-CORE.
•
For Juniper Networks systems with AC power supplies, an external surge protective
device (SPD) must be used at the AC power source.
Compliance Statements for EMC Requirements
•
Canada on page 23
•
European Community on page 23
•
Israel on page 23
•
Japan on page 23
•
United States on page 23
Copyright © 2016, Juniper Networks, Inc.22
MX104 3D Universal Edge Routers Quick Start
To Next Page
Loading...
Need help?
General