Chapter 3 Configuring the Device
10 User’s Guide
For information on creating different levels of administrators, see the “Administration”
chapter in Volume 3 of the NetScreen Concepts & Examples ScreenOS Reference Guide.
VERIFYING EXTERNAL CONNECTIVITY
To verify that workstations in your network can access resources on the Internet, start a
Web browser from any workstation in the network and enter the following URL:
www.juniper.net.
RESETTING THE DEVICE TO FACTORY DEFAULTS
If you lose the admin password, you can reset the NetScreen-5GT to its default settings.
This destroys any existing configurations, but restores access to it.
You can restore the NetScreen-5GT to its default settings in one of the following ways:
• Using a Console connection. For further information, see the “Administration”
chapter in Volume 3 of the NetScreen Concepts & Examples ScreenOS Reference
Guide.
• Using the reset pinhole on the rear panel of the device, as described in the next
section.
Warning: Resetting the device deletes all existing configuration settings and renders
existing firewall and VPN service inoperative.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...