Table 1: Line Cards and Matching SIBs
Line Cards Using JNP10008-SF3Line Cards Using JNP10008-SF
PTX10K-LC201PTX10K-LC1101
PTX10K-LC1102
PTX10K-LC1104
PTX10K-LC1105
QFX10000-60S-6Q
You can remove a fan tray on unpowered systems, or use the show chassis hardware models CLI command on running
systems to determine which type of switch fabric is installed.
Before you install a line card in the router chassis:
•
Ensure that you have the following parts and tools available to install a line card in the router:
•
ESD grounding strap
•
Phillips (+) screwdriver, number 2
To install a line card in the router chassis:
1. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD point on the router chassis. The
ESD point is located above the status LED panel on the front of the router chassis. See Figure 9.
Figure 9: ESD Point on PTX10008 Chassis Front
1—ESD point
2. Remove the line card cover by grasping the handles and pulling straight out to expose the slot for the line card. See
Figure 10.
12
To Next Page
Loading...
