Figure 10: Removing the Cover Panel for a Line Card
CAUTION: Do not lift the line card by holding the edge connectors or the handles on the
faceplate. Neither the handles or the edge connectors can support the weight of the line card.
Lifting the line card by the handles or edge connectors might bend them, which would prevent
the line cards from being properly seated in the chassis. See Figure 11 and Figure 12.
Figure 11: Line Card Connectors on 14.4 Tbps Line Cards
Figure 12: Line Card Connectors on Non-400 Gbps Line Cards
1—Connectors
3. Remove the line card from the electrostatic bag and inspect it for any damage before installing it into the chassis.
13
To Next Page
Loading...
